Home/Support/Support Forum/xbee S6b TX/RX ISSUE

xbee S6b TX/RX ISSUE

0 votes
i AM Using XBEE S6B Wi-Fi module Connected to microcontroller COM port as shown below

Microcontroller Com Port XBee S6B Wi-Fi
RS-232 type
> DOUT(tried switch RX/tx TOO)
Vcc(5V) --> Xbee regulated --> vin(PIN 1)
GND --> Xbee regulated --->GND(10 PIN)

I am able to connect my phone to XBee S6B and receive the data from the XBee but I am not able to transmit any data from my serial terminal on phone to XBee Wi-Fi.

I configured the XBee in SOFT AP MODE,TCP IP PROTOCOL, 9600 and gave an SSID .
Using XBee regulated for 5v to 3.3 v supply.

Did I miss anything. Why I am able to receive but not transmit over phone .
asked Feb 2, 2017 in IEEE 802.11 (Wi-Fi) by teja New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
What about the port number you are using? Also make sure that you use a 3V to 5V level shifter between ALL of the XBee modules pins to your 5V device as the XBee is NOT 5V tolerant.
answered Feb 21, 2017 by mvut Veteran of the Digi Community (15,408 points)