Home/Support/Support Forum/Is there any documentation on how to control XBee sensors

Is there any documentation on how to control XBee sensors

0 votes
hello,

I have 2 XBee (Zigbee) sensors that I want to connect to my my Zigbee coordinator.
I have started with one and I am stuck on the way to get access to the input data (temperature/light).
I can configure (PAN ID and coordinator address) the module through XCTU, but no way to have access to data. I believe that it was suppose to send data autonomously. The IR command is not available. I have tried the IS command, but got an error.

I haven't found any available documentation on detailed operation.

The front LED is blinking fast, but I am not able to check if this is normal or a sign of failure.

Thanks
asked Feb 21, 2017 in RF Solutions and XBee by Sterwen New to the Community (6 points)

Please log in or register to answer this question.

1 Answer

0 votes
You need to use API mode and issue an IS command. You then need to calculate the data.
answered Feb 21, 2017 by mvut Veteran of the Digi Community (11,300 points)
...