Home/Support/Support Forum/ring topology using XBee s2c and Arduino

ring topology using XBee s2c and Arduino

0 votes
Hi, I am trying to create different topologies (complete, ring, etc) using Xbee s2c and Arduino. How can I make this? My idea is to test some gossip algorithm over this topologies.
asked Mar 8, 2017 in RF Solutions and XBee by mtileria New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
As far as the radios are concerned, I would use them in the 802.15.4 configuration/firmware and at defaults except for use API mode. Then it is a simple matter of sending the data to the node you want to send it to. Especially if they are all in range of each other.
answered Mar 8, 2017 by mvut Veteran of the Digi Community (15,323 points)