First I apologize for my English, I im Swiss.
So, my problem is: I use 2 Xbee in API mode --> coordinator/end device.
On my xbee remote:
I have one led connected on the pin DIO0, and one on the pin PWM0.
I output high the pin DIO0 --> My led turn-on. Great !
I make the same for my PWM0 led, I set the PWM0 at 50%. Great! It also works.
But after some second, all LEDs turn off for 20 ms and only the LED DIO0 comes on again.
I don't know how to fix this "bug".
I have a look on all forums, and can not figure out how to fix this.
Thank you for your reply and Bonne journée