Home/Support/Support Forum/Xbee "bug" API mode

Xbee "bug" API mode

0 votes
Hi !

First I apologize for my English, I im Swiss.

So, my problem is: I use 2 Xbee in API mode --> coordinator/end device.

On my xbee remote:

I have one led connected on the pin DIO0, and one on the pin PWM0.

I output high the pin DIO0 --> My led turn-on. Great ! :D

I make the same for my PWM0 led, I set the PWM0 at 50%. Great! It also works.

But after some second, all LEDs turn off for 20 ms and only the LED DIO0 comes on again.

I don't know how to fix this "bug".

I have a look on all forums, and can not figure out how to fix this.

Thank you for your reply and Bonne journée :D
asked Mar 22, 2017 in RF Solutions and XBee by Tim Grasset New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Are you communicating between the radios at all? Or are you just using the pins to power some LEDs?
answered Mar 24, 2017 by DystopianFerret Veteran of the Digi Community (368 points)
I found my problem, I made a mistake with the pull up