Your manual shows like this.
AR (Aggregate Routing Notification)
This command applies to the XBee/XBee-PRO ZigBee RF Module.
Set or read the periodic time for broadcasting aggregate route messages. If used, these messages enable many-to-one routing to the broadcasting device. Set AR to 0x00 to send only one broadcast, to 0xFF to disable broadcasts, or to other values for periodic broadcasts in 10 second units.
I set AR 0 (once) or AR 6 (once every 60 seconds).
Then my coordinator got a lot of route record indicator (0xA1) messages continuously.
They were more than my sensor's report messages..
It didn't stop.
It was not that I expected...
I set AR FF...But it didn't disable broadcast...
My coordinator still got a lot of route record indicator (0xA1) messages continuously.
It was not that I expected, too.
I set NR 1 , then it stopped....
How can I use AR command?
If I made a mistake, let me know that..