Xbee S2C RPSMA Antenna Problem

Recently I bought 3 Programmable Xbee from mouser but there is problem with these modules. Sometimes it connects to PC, sometimes not. Can anyone help me with this issue and i found that there is short between signal line and ground of the RPSMA connector.

asked Apr 5, 2017 in ZigBee PRO Featureset (and legacy ZNet 2.5) by santosh_funambolo New to the Community (0 points)
recategorized Apr 7, 2017 by mvut

Please log in or register to answer this question.

1 Answer

What interface board are you using to connect the XBee to PC?

answered Apr 5, 2017 by DystopianFerret Veteran of the Digi Community (368 points)

Xbee Grove Dev. Bd

commented Apr 6, 2017 by santosh_funambolo New to the Community (0 points)

Is the device configured as an End device?

What is the full part number of the module in question?

commented Apr 7, 2017 by mvut Veteran of the Digi Community (15,320 points)

I'm having the same problem. I'm using a Xbee USB Adapter V2.1 from www.DFRobot.com

https://www.dfrobot.com/product-588.html

Thank you!

commented Feb 18, 2020 by GerardoMC New to the Community (0 points)

Gerardo and Funanbolo,

If this is the S2C module with the Zigbee firmware version installed, you enable the end device function by enable the sleep function (SM).

Eric
Digi Support

commented Feb 18, 2020 by mvut Veteran of the Digi Community (15,320 points)

Xbee S2C RPSMA Antenna Problem

Please log in or register to add a comment.

Please log in or register to answer this question.

1 Answer

Please log in or register to add a comment.