Home/Support/Support Forum/End device (E) and Router (R) communication is not working using Xbee

End device (E) and Router (R) communication is not working using Xbee

0 votes
I am trying to make following topology in API mode. End device (E) <--->Router (R) <----> coordinator (C) Is it feasible ? I have configured both xbees in API mode (2). I am not able to see communication happening between end point and router in APi mode. Please help to fix this.

However, following topology is working: Router (R) <---> Coordinator (C)
asked May 12, 2017 in IEEE 802.15.4 by jyot.su New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
When using Zigbee, unless you are using Source Routing, you don't see the rout. It happens all on its own.
answered May 12, 2017 by mvut Veteran of the Digi Community (15,323 points)
...