Home/Support/Support Forum/Rx timeout on API commands parsing

Rx timeout on API commands parsing

0 votes
Hello there,
I have a question regarding incoming (Send to the Xbee from an external MCU) data through the uart interface. If I operate in API mode with the Xbee, what is the maximum time between each sent byte before Xbee module will have a reception timeout?
Lets say I want to send an AT command from MCU to the Xbee. Instead of sending all bytes at once, I stopped for a while (a time larger than the in between bytes time that comes from the baudrate) after 3rd byte and then wanted to continue. Will Xbee wait for the second part of the command or yeld a timeout after first part and then misunderstand the second part?
I would appreciate all help.
asked Jul 18, 2017 in DigiMesh Proprietary Mesh Networking by bremenpl New to the Community (3 points)

Please log in or register to answer this question.

1 Answer

0 votes
When using API mode, i am not aware of any timeout period being implemented. It is just a matter of when the full packet is received.
answered Jul 18, 2017 by mvut Veteran of the Digi Community (15,410 points)
Are there no conditions in which packet transmission is interrupted/ canceled?
Just a reset or power cycle.