Home/Support/Support Forum/xbee cellular on XCTU command mode

xbee cellular on XCTU command mode

0 votes
Hi,

I am using xBee cellular kit with XCTU to communicate with the modem.
I can read/write/edit the values in the Configuration mode.
But I cannot use it in the command mode in the console.

I am trying to create packet and then press 'Send selected packet'. I never get a reply back from the modem. It only responds with 'OK' for the '+++' packet. I have tried ATVL, ATVR, ATIM commands. But the modem never replies anything back.

Do I need to specify <CR>, <LF> in the packet? Am I missing some setting for the command mode?


Thanks & Regards,
Anuja Upale
asked Aug 8, 2017 in XBee Cellular by anuja.upale New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Yes once you are in command mode, you need to issue the <CR> to issue an AT command. For example,


+++
ok
ATVR<CR>
Response <CR>
answered Aug 8, 2017 by mvut Veteran of the Digi Community (11,963 points)
...