Home/Support/Support Forum/communication between arduino via xbee pro s3B

communication between arduino via xbee pro s3B

0 votes
i tried to make mesh network between arduino via xbee to send it location to each other using vk16el module i can't make sender and reciever to same controller i think the problem with configuration to xbee , what is the best configuration to it to make communication good
asked Sep 5, 2017 in RF Solutions and XBee by dania_alkhateeb New to the Community (3 points)

Please log in or register to answer this question.

1 Answer

0 votes
What is the full part number and firmware version on your XBee?
answered Sep 5, 2017 by mvut Veteran of the Digi Community (12,001 points)
XBP9B-DM XBeePRO 900HP 200K firmware version 8074
For the Arduino hardware, you use API mode (AP1).  For your remote device, you most likely will use transparent mode with the DL and DH set to the SL and SH of the base module on the Arduino.
...