Home/Support/Support Forum/Further problems with Industrial Automation to communicate XBee Analog Adapter and ConnectPort X2D

Further problems with Industrial Automation to communicate XBee Analog Adapter and ConnectPort X2D

0 votes
I am using a software that is able to talk to Modbus devices over TCP, which is addressed through the IP of the ConnectPort X2D. I have configured Industrial Automation of the CPX2D to have an Analog XBee Adapter in an specific address (with its RF MAC address), but I am still having connection problems when trying to access the analog registers in the XBee adapter. How can I forward RTU serial messages from mesh network to the CPX2 and out of it with MODBUS TCP?

Many thanks
Regards
asked Sep 5, 2017 in NDS-based Gateways by Garco New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
If you are are using the Industrial Automation function in the CPX it should do that for you. You may just need to adjust your timeout values in your Server.
answered Sep 6, 2017 by mvut Veteran of the Digi Community (11,302 points)
...