I have 2 XBEE S2C. One as coordinator , the other as router. Firmware version : 405F
My XBEE's are plugged into a groove dev board. I'm playing with XCTU and some com port logging tool.
I'm testing now one RB innr 175 W smart lamp. (which should work with philips Hue and Osram Lighify)
With my 2 boards I can do remote AT commands to control leds on the groove board and so on. That seams to be working.
Now I'm trying to have a smart device (innr lamp) connected so I can control the lamp by sending commands.
In the XCTU when I do a 'scan' I see the end device but it seems it does not join.
I see Max address:00158D00017C529F, netw addr5381, type router and 'unknown ?LQI'
If I click on the device in the scan window from the XCTU I get a message '.....device sleeping or not in the network any more'
I did enable the encryption EE=1,EO=1 KY=5A6967.....
So here I'm lost....
- should the joining of the lamp with the coordinator by done 100% auto without need of serial commands via the XCTU? The beacon/association process.
- Can I should I see beacon communication on my serial? Or is this handled at lower layer.
- I was trying to setup my second Xbee as transparent to see if I could sniff beacon packages but no success.
Thanks if someone could point me in the right direction! I'm new to this so still learning.