Home/Support/Support Forum/IAS Zone Cluster Reporting at Fixed Interval Time

IAS Zone Cluster Reporting at Fixed Interval Time

0 votes
I have some IAS Zone motion sensor and door sensor but sometime they can go for months without triggering. How can I get them to report at fixed interval time so I would know that they are still working?e.g. hourly, daily
I have checked from Zigbee Cluster Library that under the cluster ID (0x0500 - IAS Zone Cluster), there is only one command ID that I can send from my hub which is (0x00 - Zone Enroll Response). Is there a way to make the sensors response back when I send them something?
asked Sep 11, 2017 in RF Solutions and XBee by wimpetus New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
Best answer
If the standard does not provide any additional commands, then the answer would be no. But I would check with the manufacture of the Sensor to verify that.
answered Sep 11, 2017 by mvut Veteran of the Digi Community (15,413 points)
selected Sep 14, 2017 by wimpetus