Home/Support/Support Forum/Xbee Pro s2c Encryption issue

Xbee Pro s2c Encryption issue

0 votes
I have 3 xbee S2c pro modules. Irrespective of all factor default setting for each xbee i have enabled encryption option for all 3 xbees. I have set specific key for xbee 1 and 2 and different key for xbee 3.

My problem is, transmitting any data from xbee 3 will alter my xbee 1 and xbee 2 communication with some garbage bytes. How can i avoid xbee 1 and xbee 2 from receiving any garbage bytes from xbee 3?
asked Sep 19, 2017 in RF Solutions and XBee by maverick New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
You need to configure module 1 and 2 to use authentication. This will keep Node 3 from joining the network.
answered Sep 19, 2017 by mvut Veteran of the Digi Community (11,961 points)
How to configure module 1 and 2 to use authentication? I have already set AES encryption enable. I also would like to add that all my xbee's are as END DEVICEs. There is no coordinator-router-end devices network.
In order to form a Zigbee mesh network, you MUST have a Coordinator.  It is REQUIRED....
...