Home/Support/Support Forum/Publish pose data to swarm drone via xbee sub1G

Publish pose data to swarm drone via xbee sub1G

0 votes
Hi

I'm doing drone swarm system indoor with motion capture. The motion capture needs to publish drone 6dof data to each drone wireleely. It requires low time-delay and resist to noise. So, sub-1G seems to be the best option.

I tested xbee-pro-900hp module. Its bandwidth allows to publish 10 drones data. If I want to increase drone numbers, any methods to increase bandwidth capacity?

Data specification,
Each drone: [x,y,z,roll,yaw,pitch], double array, 48 bytes;
Drone number: 50
Publish rate: 30 Hz

Thanks
asked Sep 20, 2017 in DigiMesh Proprietary Mesh Networking by chuhao New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
There are a few commands that may help but it it is big may.

Try setting RR0x00, MT0x00, TO0x40 MR0x00
answered Sep 20, 2017 by mvut Veteran of the Digi Community (15,413 points)
Do you have related link? What does these commands mean?

Thanks
...