Home/Support/Support Forum/XB24C 401E firmwave how to update
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

XB24C 401E firmwave how to update

0 votes
excuse me. When I connected the radio module(XB24C 401E), XCTU shows a message"could not find a firmware......" , then, i updated many times. but the error message always appeared.
error message (screen shot):
https://imgur.com/BixW001

Anyone suggest me how to do?
asked Nov 1, 2017 in USB Serial by longerplus New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
how are you connecting the XBee to the PC? What or who's board are you connecting it to? What is the full part number for the XBee module you are working with?
answered Nov 1, 2017 by mvut Veteran of the Digi Community (14,777 points)
Thanks a lot for your reply.
I used the connecting board made by Silicon Labs (CP210x USB to UART). and the specification of ZigBEE is shown in the link: https://imgur.com/a/ZxIOJ
get it from XCTU (ver. 5.2.8.6)
or you mean the IC number:
https://imgur.com/a/Gudmz
commented Nov 2, 2017 by longerplus New to the Community (0 points)
Your additional label you put on the module is covering the part number for the XBee.

What pins does this 3rd party board use?  For firmware upgrades, VCC, GND, Di, Do, DTR and RTS are required.
commented Nov 2, 2017 by mvut Veteran of the Digi Community (14,777 points)
...