Home/Support/Support Forum/Serial communication with two XBee using serial monitor

Serial communication with two XBee using serial monitor

0 votes
Hi, I recently bought 2 Xbee 1mw series 1 wire antenna and I connected both of them to arduino board. At the same time, I managed to configure them on XCTU and get them to transmit data bwtween each other on the serial monitor within XCTU. However, I was wondering is it possible to allow both XBee to communicate with each other within the serial monitor of arduino without going through XCTU. If it is possible, I need some help in understanding how to do it. Thanks.
asked Nov 1, 2017 in IEEE 802.15.4 by Panda01 New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
That is not a function of the radio but a function of the Arduino. This is really something you need to ask on your Arduino's site.
answered Nov 2, 2017 by mvut Veteran of the Digi Community (15,410 points)