Home/Support/Support Forum/Is it necessary to connect Vref pin somewhere using XBee Series 2?

Is it necessary to connect Vref pin somewhere using XBee Series 2?

0 votes
Hi everybody!
I have an XBee Series 2 working with a SHT30 sensor(Temperature and Humidity Analog Sensor). The outputs of the sensor are in a range of 0.3-2.9 V, so I did a voltage divider in order to the signal was in the range of 0-1.2 V. The problem is that the samples I receive doesn't make much sense... So my question is, I have to connect the Vref pin to Vcc, GND or something?
Thank you so much in advance!
asked Nov 7, 2017 in Miscellaneous Hardware and Software by Jserra New to the Community (1 point)

Please log in or register to answer this question.

2 Answers

0 votes
No it is not.
answered Nov 7, 2017 by mvut Veteran of the Digi Community (15,320 points)
0 votes
ok thanks, so any idea? What can be wrong? The sensor's outputs are right because I checked it out with the diagrams of the datasheet, but the data adquisition is wrong and I don't know why... Can anyone help me?
answered Nov 10, 2017 by Jserra New to the Community (1 point)
...