Home/Support/Support Forum/How to upgrade from anywhereusb2 to anywhereusb5
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

How to upgrade from anywhereusb2 to anywhereusb5

0 votes
I have been using anywhereusb/2 for a while now. We've just purchased an anywhereusb/5 G2 to replace the anywhereusb/2.

Are there recommended steps for replacing the older device with the newer, maintaining as much of the existing configuration as possible?
asked Nov 14, 2017 in USB by dgd2 New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
1. Configure the AWUSB/5 G2 with a static IP address, so it's on the same subnet as the host computer (the Windows-based computer that has the AWUSB software installed). Use the Digi Device Discovery Utility to do this.

2. Make sure you can ping the AWUSB/5 G2 from the host computer, and access the web interface of the AWUSB/5 G2.

3. The AWUSB/5 G2 should appear on the left-hand side of the AWUSB Configuration Utility (but it it doesn't, add the IP address of the AWUSB/5 G2 to the Connection List, via "Edit / Connection List").

4. Select the AWUSB/5 G2 and click the Connect button. All 5 of the USB Port LEDs should turn solid Green, indicating a successful connection.

5. Remove the USB devices from the AWUSB/2 and attach them to the AWUSB/5 G2. They should automatically install.

6. Disconnect the AWUSB/2 from the host computer by selecting it (in the AWUSB Config Util) then clicking the Disconnect button.

That should be all there is to it.
answered Nov 15, 2017 by jeremym Veteran of the Digi Community (1,673 points)
...