Home/Support/Support Forum/It did not work, what do I do?

It did not work, what do I do?

0 votes
I have a problem just like yours. I have same model of xbee and my xctu is 6.3. Please tell me step by step how you solved it, I could not understand what you did to solve.
related to an answer for: XCTU problem with S2C modules
asked Nov 15, 2017 in RF Solutions and XBee by evandrojr18 New to the Community (3 points)

Please log in or register to answer this question.

1 Answer

0 votes
What I would do is open a terminal window on the same COM port but enable the break and assert RTS. Then hit the rest button on the interface board. deselect the break and issue a <CR>. A menu will come up. Pressing B will put you in bypass mode. Once in bypass mode, use the same steps as before to write the new firmware to the module.
answered Nov 15, 2017 by mvut Veteran of the Digi Community (11,965 points)
...