Home/Support/Support Forum/iomux port setup discrepancy for connectcore 6ul sbc pro
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

iomux port setup discrepancy for connectcore 6ul sbc pro

0 votes
I've noticed a discrepancy in iomux when starting from template for CC6ul SBC PRO wifi/bluetooth.
The UART labeled as "Serial port" is mapped as "UART2", while the schematic for the same board shows "UART3" is connected. And vica versa for the UART labeled "Xbee".

So it seems like the UART port references (UART2, UART3) are wrong in IOmux tool.

asked Nov 22, 2017 in Embedded Devices by andreastaran New to the Community (6 points)

Please log in or register to answer this question.

1 Answer

0 votes
The team was already aware of this. This has been already fixed and will ready for the next release of the tool.
answered Dec 1, 2017 by LeonidM Veteran of the Digi Community (4,454 points)