Home/Support/Support Forum/XBEE ZB End Device not joining network

XBEE ZB End Device not joining network

0 votes
I have 3 nos of XBEE PRO S2 radios. I have configured them as coordinator, router and end device respectively by changing their firmware using X-CTU.

Coordinator: XBP24-ZB, 21A7, API2
Router: XBP24-ZB, 23A7, API2
End Device: XBP24-ZB, 29A7, API2

ID, SC, ZS, Security n all necessary parameters are same for all three.
For Coordinator & Router joining is permitted.
Coordinator and router is connected with good LQI on both side (255/255).
End device is not joining the network.
Coordinator ---> End Device LQI: 255
End Device ----> Coordinator LQI: ??

I'm really stuck with this. Could anyone help me out?
asked Nov 30, 2017 in RF Solutions and XBee by ch123 New to the Community (0 points)

Please log in or register to answer this question.

...