Home/Support/Support Forum/XBee Data read through serial problem

XBee Data read through serial problem

0 votes
Hi. I've used Xbee pro s1 for my project.

Tx sends data to receiver and the data is transferred through serial interface device
like ICStation's mini adapter or NERO XBEE EXPLORER(without arduino or sth).

Problem is after quit python program(handles received data),
I must pull out xbee connector from my laptop and re-connect it to read the data.

I use MacBook Pro (Retina, 15-inch, Mid 2015), and os version is 10.11.6(El Capitan)
& use spyder 3.2.4 for ide.
(Same problem occurred on High-Sierra so I downgraded but same thing happens)

Test code is below
ser = serial.Serial("/dev/cu.usbserial-DA1D4B4P") # my usbserial port


while True :
It works well for the first time I execute above program,
but after that, there's no response from the device.

Every time I stop the current command when there is no response,
stop at the sequence below

ready, _, _ = select.select([self.fd, self.pipe_abort_read_r], [], [], timeout.time_left())

There's no difference with or without FTDI driver.
Is there any suggestion to solve this problem?

Best regards
asked Jan 25, 2018 in RF Solutions and XBee by qlqqkq New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
This is really not an XBee issue but an issue with your code and how you are opening and closing the socket and doing your reads/ writes in your code.
answered Jan 25, 2018 by mvut Veteran of the Digi Community (15,408 points)