Home/Support/Support Forum/Xbee 868LP and SPI

Xbee 868LP and SPI

0 votes
Hi,

I am using an Arduino zero to send SPI messages through XBee. I have configured all of the SPI pins to their respective SPI functions in XCTU, and am using API mode 1 (API mode with escapes).

I then send an SPI message with API frame via SPI, after driving SPI_SSEL low. I can see with the scope that the message is received at the MOSI pin, and the SSEL does in fact go low, however the message is not being transmitted and I cannot pick it up with another Xbee connected with a Dogo explorer to my computer on XCTU.

Is there something glaringly obvious that I haven't done?

Thanks in advance.
asked Jan 25, 2018 in RF Solutions and XBee by helzbo New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
what is the API frame you are sending?

Have you enable the SPI pins in the radios firmware?
answered Jan 25, 2018 by mvut Veteran of the Digi Community (14,818 points)
wrong question sorry
...