Home/Support/Support Forum/How to run a kernel project config in ESP
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

How to run a kernel project config in ESP

0 votes
I'm resurrecting a 2009 project to build additional units with some small upgrades. I seem to be having a lot of issues, but many are I believe related to the kernel config. I can't runt the config from the IDE because it flashes some error too fast to see and then continues with the build. When I run "make -k gconfig" on the project I get the following;

HOSTLD scripts/kconfig/gconf
make: *** [gconfig] Error 2

I'm not sure but I'm thinking maybe a Glade update broke it? Any advice would be greatly appreciated.

Thanks
asked Feb 21, 2018 in Linux by Glenn Hamblin New to the Community (5 points)

Please log in or register to answer this question.

1 Answer

0 votes
I assume you are using Digi Embedded Linux and digi ESP.
you can try xconfig, qconfig or gconfig. make sure you have them installed. Then you can choose a tool in preferences dialog. DigiEL Configuration--> Graphic window system. uncheck autodetect and type in gconfig, xconfig or qconfig. you can probably even do menuconfig.
to get xconfig and gconfig:
sudo apt-get install libgtk2.0-dev libglib2.0-dev libglade2-dev
sudo apt-get install libqt3-headers libqt3-mt-dev
answered Feb 25, 2018 by LeonidM Veteran of the Digi Community (3,028 points)
...