Home/Support/Support Forum/How do you configure Zigbee HA1.2 on DIGI S2C.
New and improved user forum site coming soon

How do you configure Zigbee HA1.2 on DIGI S2C.

+1 vote
I have a DIGI S2C with which I want to create a home automation HUB. I am trying to configure the digi device with HA1.2 capability so that we can connect with HA1.2 end devices. I will appreciate if one could point us to any documentation as to how to set up a HA1.2 Coordinator.
asked Mar 5, 2018 in XCTU by rnavanee New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
Make sure to flash the Chip with the ZigBee Firmware.

Then use XCTU or the AT Commands directly to set the following values :

ZigBee Stack : ZS = 0x02
API Enable : AP = 0x01
API Mode : AO = 0x03
Encryption Enabled : EE = 0x01
Encryption Options : EO = 0x02
Network Key : KY = 0x5A6967426565416C6C69616E63653039

If your chip is going to act as the Network coordinator then you also ned to set :

Coordinator Enabled : CE = 0x01

If you're using the AT command to setup the modem directly, remember to issue an `WR` command to make the changes persistent.

That's it.
answered Mar 6, 2018 by Andrew Scott New to the Community (1 point)