Home/Support/Support Forum/How to restore POST.bin for Digi Connect ME 9210?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

How to restore POST.bin for Digi Connect ME 9210?

0 votes
I am able to access the manufacturing interface to TFTP an image into the Digi Connect ME 9210. However, it does not seem like it is possible to reflash the POST image from that interface.

Is there any way for me to flash a new POST.bin without access to the configuration page?
asked Apr 6, 2018 in Plug N' Play by dasher New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
why do you want to refalsh POST from TFTP? Does the module not boot?
answered Apr 8, 2018 by LeonidM Veteran of the Digi Community (3,654 points)
yeah, the module does not boot.
commented Apr 9, 2018 by dasher New to the Community (0 points)
I would strongly suspect that the problem is not corrupt POST and something else is wrong with the module. If this happens a lot I'd carefully remove and RMA the module and request Failure Analysis.
commented Apr 9, 2018 by LeonidM Veteran of the Digi Community (3,654 points)
...