Home/Support/Support Forum/After configuring xbee3 as an end device, it is not responding to the +++ and AT commands

After configuring xbee3 as an end device, it is not responding to the +++ and AT commands

0 votes
I have given the following commands to configure xbee3 as an end device
+++
ATSM1
ATCE0
ATID1234
ATWR
ATSC7FFF
ATWR
ATDH0013A200
ATDL417AD1E3
ATBD7
ATJV1
ATAC
ATWR
ATCN
asked Apr 17, 2018 in RF Solutions and XBee by LATCHABABU New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
How long are you holding the sleep pin high to wake the module and keep it awake?
answered Apr 17, 2018 by mvut Veteran of the Digi Community (14,777 points)
...