Home/Support/Support Forum/Line passing mode

Line passing mode

0 votes
Hi,

I'm using the (XBEE24 PRO 2.4Ghz PN: XBP24-AWI-001) xbee module, in Line Passing mode.
My problem is that if the power supply fails, in the module being used to remote, the receiver module continues with the activation of the active gpio pin.

Is there a setting to put the pin at 0 on the receiver module if that happens?

Thank you
asked Apr 27, 2018 in IEEE 802.15.4 by EduTruck New to the Community (1 point)

Please log in or register to answer this question.

...