Home/Support/Support Forum/Xbee S2C DigiMesh Encryption seems broken, Firmware 9000

Xbee S2C DigiMesh Encryption seems broken, Firmware 9000

0 votes
I'm trying to set up a secure network with a few Xbee S2Cs. I set up a small test with XCTU that has two nodes in transparent mode - one DH/DL set to broadcast the other set to the first node's MAC. In console mode I set the two nodes to simply transmit their name every 200ms.

With no encryption, the packets are making it to both devices no problem. WHen I switch to encrypted mode, the broadcast packet makes it to the 2nd device, but the unicast packet from the 2nd to the first doesn't make it. I only see random characters sometimes, but not the correct characters or at the expected rate.

If I switch the broadcast / unicast roles, the broadcast is still the only direction that works.
asked May 3, 2018 in DigiMesh Proprietary Mesh Networking by Bob1974 New to the Community (0 points)

Please log in or register to answer this question.

...