Home/Support/Support Forum/Routing Table Limit
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Routing Table Limit

0 votes
Can you advise the maximum limitation for dynamic routing tables on WR41/WR44/WR31 Digi transport? More specifically - OSPF and static routing.
asked May 8, 2018 in Digi TransPort Cellular by g9000 New to the Community (2 points)

Please log in or register to answer this question.

2 Answers

0 votes
There is a limitation in the number of routes that can be passed in the updates over OSPF i dont remember the Number but it is in the hundreds.

if you are passing that many you should summaries the routes to reduce the number.

regards

james
answered May 8, 2018 by James.Wilson Veteran of the Digi Community (1,227 points)
0 votes
Does the Digi operating system support OSPF/Stub as an alternative?
answered May 9, 2018 by g9000 New to the Community (2 points)
I think you will find the OSPF implementation is quite restricted and if i remember correctly it does not support STUB networks.  if you are only intrested in pushing down the default router for GRE you could just setup default route pointing to the GRE tunnel and make sure there is static route to the IP address to the headend of the GRE and if GRE keep alives are enabled then the Default route would be down while GRE is DOWN

hope this helps
commented May 15, 2018 by James.Wilson Veteran of the Digi Community (1,227 points)
...