Home/Support/Support Forum/Trying to setup XBee Wifi point to point using API Mode.
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Trying to setup XBee Wifi point to point using API Mode.

0 votes
Assuming defaults, what should I set to get 2 XBee Wifi modules to communicate? I tried following the manual but I've had no luck. I keep getting ACK failures or invalid UDP port errors. Thanks
asked May 22, 2018 in IEEE 802.11 (Wi-Fi) by mattcorcoran New to the Community (1 point)

Please log in or register to answer this question.

...