Home/Support/Support Forum/How to Read analog data from remote XBee
New and improved user forum site coming soon

How to Read analog data from remote XBee

0 votes
Hello everyone,

I try to read analog dato from my xbee but i allways get 1023 as a result on every pin ADC i can try (AD1, AD2 or AD3...)

The Xbee connected to my temp sensor is on "End Device" mode.
DIO1 , 2 , 3 and 4 are set to ADC mode.

On my Coordinator Xbee all i get are the same value :
ADC1 : 1023
ADC2 : 1023
ADC3 : 1023
ADC4 : 1023
Even if nothing is connected to those pins...

What's wrong ?

asked Aug 27, 2018 in XBee3 by garraty_ray1 New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
Hi. The first thing is to check the output voltage of the sensor and that is effectively entering that voltae in the corresponding analog input, you could also check the IR (io sampling rate) parameter that must be greater than zero

answered Sep 19, 2018 by JSOSA New to the Community (5 points)