Home/Support/Support Forum/XBee and Ucam III

XBee and Ucam III

0 votes
I am using a legacy S1 XBee connected to a PCA grove development board.
Using the software with the Ucam in question im attempting to usethe XBee as a serial connection to the camera. the problem is that I see the TX light flashing so that I know the command is going in but the RX light isn't flashing signaling that it is being forwarded to the camera, how can I use the XBee to forward this signal?
asked Sep 10, 2018 in XBee Cellular by Last New to the Community (0 points)
recategorized Sep 11, 2018 by rmaroun

Please log in or register to answer this question.

...