Home/Support/Support Forum/XBee 900HP Reset

XBee 900HP Reset

0 votes
Greetings,

I am using the XBee-PRO 900HP RF Module and however, I am having issues communicating with the device. I do not get any response from any commands. I connected a digital serializer to see that I am indeed sending commands to Pin 3 (the UART input) at settings of 9600 Baud, No Parity, width 8, 1 stop bit. This module was taken right out of the box and inserted. Do I need to do any preconditioning? My reset line is at 2.4V does that satisfy the requirement for it to not be stuck in reset?

Any suggestions would be helpful!

Thanks!
asked Sep 17, 2018 in Interface/Development Boards by Burgeh New to the Community (0 points)
I found communication to be possible, but I still am wondering about the reset line.

Please log in or register to answer this question.

...