Home/Support/Support Forum/Digi Transport Heartbeat Port
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Digi Transport Heartbeat Port

0 votes
I am enabling the heartbeat messages on Digi Transport devices but I cannot find any documentation stating which port these messages are sent to. Does anyone know?
asked Oct 25, 2018 in Digi TransPort Cellular by trpropst New to the Community (4 points)

Please log in or register to answer this question.

1 Answer

+1 vote
 
Best answer
Hi

I did a analyser trace and it looks to be 4051 UDP

if that helps

regards

James
answered Oct 26, 2018 by James.Wilson Veteran of the Digi Community (1,187 points)
selected Oct 26, 2018 by trpropst
Thanks, James. You've now prompted another question. When I attempt an analyzer trace, the IP filters do not take effect. I've added my PC address to the "IP Packet Filters | IP Addresses" field and hit "Apply". When I clear and refresh the trace, my PC address still accounts for a large number of packets. Do you have this issue as well?
Hi if you added the address to the IP filter have you enabled the IP interface ot the ETH interface..

The Filters on work on IP interfaces

and you have added the address without the "~" to  negate the address
I just tested this scenario:
- Only connecting over PPP1
- Connected from two IP addresses (one for config changes, one for ping test)
- Enable analyzer trace only on Layer 3, only on PPP interface PPP1, and only on IP source PPP1.
- IP packet filter = ~<ping test IP> (using tilde here to try and only capture ping traffic)
- Apply, save, clear the trace

I see all traffic from the config system IP in the trace. I expect to only see the pings.

Can you see an issue with my approach?
...