Home/Support/Support Forum/loose connection in xbee programmable board

loose connection in xbee programmable board

0 votes

I am using programmable xbee with the kit available on mouser. As far as the prototyping is considered, it is is fine. But now the connection of the jumper wires is too loose for a proper project. Any idea what can be a solution for this? Any jumper wires that would be in them and wont come off?

Kind regards,
asked Oct 29, 2018 in XBee Programmable Development by khawaja.mustafa New to the Community (3 points)

Please log in or register to answer this question.