Home/Support/Support Forum/XBEE 3 802.15.4 remote module configuration

XBEE 3 802.15.4 remote module configuration

0 votes

I have recently bought a Xbee Zigbee mesh kit for my project.I need to use this in Point to Multipoint network (802.15.4 mode).

I have updated the firmware and followed this guide to configure the remote devices by changing the ID,NI,AP mode.


But i could not succeed establishing a connection between two Xbees. I have also tired changing one Xbee as Coordinator and other as End device / both as End device. But i got no progress.

Any answers or suggestions will be very much appreciated.
asked Nov 15, 2018 in XBee3 802.15.4 by chandru New to the Community (3 points)

Please log in or register to answer this question.