Home/Support/Support Forum/SBC BL2100 programming error.
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

SBC BL2100 programming error.

0 votes

I have a Single Board Computer and I want to programming it. SBC model is BL2100. I have a error message while I load a sample program. Error message “No Rabbit processor Detected.”

I applied the troubleshooting process on user manual but I have still same error. I am using USB Programming Cable. Its product number is 20-101-1201.

What can I do? How to resolve this issue?

Thank you. Regards.
Ismail CIL
asked Jan 4 in Rabbit Software by ismail.cil New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
That's the correct cable. I would check the following:

- You're using Dynamic C 9.62 or earlier. Dynamic C 10 is for newer products (based on Rabbit 4000, 5000 and 6000).
- You have selected the correct serial port. You can verify by seeing the selected port disappear from port lists when you unplug the cable.
- The BL2100 has power.
- You're using the "PROG" and not "DIAG" connector on the programming cable.
- The red edge of the ribbon cable matches the pin 1 marking of the programming connector (silkscreen dot, typically the edge of the board).

Hope that helps.
answered Jan 10 by TomCollins Veteran of the Digi Community (1,310 points)