Xbee3 802.15.4 - problem - I'm migrating to XBEE3.

Question

I already use the XBEE S1 and S2 module in my product, I'm migrating to XBEE3.
With the XBEE S1 / S2 modules, everything works fine.
In XBEE3 with the UART firmware 802.15.4, either it works for a while and stops, or when you turn it off and on again it stops working. Are there configurations that can solve this problem?

Answer 1

Good morning,
I'm also having a problem with S3 module.
Our configuration is half duplex communication in a broadcast way of work.
It works for approx one hours then the XBEE 3 module seems to stop. Sometimes, even a hard reset is not enough to make it work again.
I have test my system with S2 modules.
Is there a solution to fix this problem ?

Answer 2

I am having the same trouble. No issues with the S1, but the XBee3 module locks up and I have to cycle the power to fix it. It seems to be something with the message format or timing. I can send much larger packets faster using a protocol analyzer and it works fine. I'm using the international version of the XBee3 and the Pro version of the S1.

Answer 3

I'm having similar issue with XSTICK1 and XBEE3 with 802.15.4 firmware. No issues with S1 and XSTICK1

Answer 4

Good morning,
I have tested my system with XBEE PRO V2 (still in 802.15.4 mode) and I don't have my previous problem anymore.
The XBEE PRO 3 in 802.15.4 mode really seems to be bugged.

Answer 5

same problem... on 802.15.4 mode. Work fine with S1 pro and S2 also.
But S3 seem to stop transmitting after a while ( random time). A power on/off solve the problem for a while, also a hardware reset on the reset pin. But nothing else reset the device. I have revision 2006. I try upgrade to 200A, no difference.
This is very concerning... and no answer from DIGIT!