Home/Support/Support Forum/advice on PS design for XBEE3 CAT-M

advice on PS design for XBEE3 CAT-M

0 votes
I am looking at the CAT-M module. In the past I have just shut down and powered down the cellular modem to save power but for CAT M the built in LTE PSM would be better I think. However that requires that the power supply regulate from 10ua to 750ma which is a challenge. Do you guys have any suggestions.
asked Feb 5 in XBee Cellular by davidmundie New to the Community (0 points)

Please log in or register to answer this question.