Home/Support/Support Forum/TouchPanel via USB on CC6UL pro
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

TouchPanel via USB on CC6UL pro

0 votes
I am working with a "ConnectCore 6UL SBC Pro" development board, so far I was working with a Fusion 7" displaw with an I2C TouchPanel, everything working as expected.

Now I need to switch the display to a bigger one with an USB touch interface, It´s supposed to work with the NTRIG driver. When I connect the usb cable, it´s detected (used lsusb), but not recognised as a touch device.

Do i need to manually add/enable the driver?, if so, where and how do I do it?, I am still a newbie with Yocto, any comments or guides will help a lot
asked Mar 1, 2019 in Linux by genzo436 New to the Community (3 points)

Please log in or register to answer this question.

1 Answer

0 votes
yes, you need a touch driver for that device enabled and kernel and in the device tree. Might be in a human interface category
answered Mar 1, 2019 by LeonidM Veteran of the Digi Community (4,411 points)