Home/Support/Support Forum/problem XBee 3

problem XBee 3

0 votes

I use the xbee 3 for serial comunnication, but i have a problem, when restart system the xbee module stop to work. The power supply was verify.

Help me please.

Thank you.
asked Mar 13, 2019 in XBee3 802.15.4 by EduTruck New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
I've the same problem, using the module for serial communication: after a power off & on, sometimes (less than 10%) the xbee 3 stops to communicate. I suspect the module goes in the boot mode. No chance to restart even using the RESET pin. To fix, I must power off & on again the module.

Do you use the same "fix" method to get to work the module?
answered Oct 14, 2021 by willy New to the Community (1 point)