Home/Support/Support Forum/Connectore6UL Linux
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Connectore6UL Linux

0 votes
I am using the ConnectoreCore6UL with custom buildroot image and I am looking for any advice for the below questions:

1) The evaluation board uses the GPIO3_IO02 as ENET1_PWR. Where is the code that control this output? I have looked in some driver file but I could not find any reference to that pin.

2) Is there any way to reboot linux without "sudo" (and so without root permission)? I do not think that including the "sudo" package in the Linux image is safe enough. Should I use an output to pull-down the "MCA_RESET_n" pin?

3) As for the above question, how can I complete the "poweroff" procedure without root permission? I think that just removing the power could damage the Linux partion, is it not right?

Thank you very much for any response.
asked May 6, 2019 in Linux by Softwork_PP New to the Community (4 points)

Please log in or register to answer this question.

1 Answer

+1 vote
Best answer
1) There is no code that currently controls this pin in driver. The pin is set as GPIO.

2) check this for example:

3) correct
answered May 7, 2019 by LeonidM Veteran of the Digi Community (4,457 points)
selected May 8, 2019 by Softwork_PP