Home/Support/Support Forum/XBee SX RF Modem pin mapping ?

XBee SX RF Modem pin mapping ?

0 votes
Hello,

I'm a bit confused on the pin layout for the RS232/485 variant of the XBee SX 900 Mhz Modem (XM-X9-3P-U). The pin diagram on Page 11 of the User Guide (https://www.digi.com/resources/documentation/digidocs/pdfs/90001517.pdf) defines signals for pins "1" through "8" on the RJ-45 connector.

I'm confused as to which pins these correspond to in the XCTU Configuration Utility, which allows configuration for D0-D9 and P0-P9. Neither of these ports seem to correspond with the mapping shown on Page 11 of the User Guide.

Also, is there any way to disable flow control? I have an RS232 device which only has RX/TX pins and no CTS/RTS.

Any help would be greatly appreciated.

Thanks,

Charlie
asked May 13 in RF Solutions and XBee by top955 New to the Community (0 points)

Please log in or register to answer this question.

...