Home/Support/Support Forum/GRE configuration more than 2 tunnels - WR11
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

GRE configuration more than 2 tunnels - WR11

0 votes
Dear all,

I've configured 2 GRE tunnels for 3 WR11 routers. However only the 1st tunnel works, the 2nd i can not ping between 2 LAN IP. I copy and paste the configuration from 1st to 2nd (of course i changed IP for connection only).

The configuration of tunnels are as below:

Tunnel 0: LAN IP of router: 192.168.1.2,
IP address: 10.10.10.1
Source IP address: 10.110.130.1
Destination IP address: 10.110.130.15

LAN IP of router: 192.168.2.2,
IP address: 10.10.10.15
Source IP address: 10.110.130.15
Destination IP address: 10.110.130.1

Tunnel 1: LAN IP of router: 192.168.1.2,
IP address: 10.10.10.1
Source IP address: 10.110.130.1
Destination IP address: 10.110.130.2

LAN IP of router: 192.168.3.2,
IP address: 10.10.10.2
Source IP address: 10.110.130.2
Destination IP address: 10.110.130.1

Could you please give me some hint for this issue?
Have i configured it correctly?

Thanks and Best Regards,
Dee
asked May 22 in Digi TransPort Cellular by dee1369 New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Hi, Did you determine what your problem was? Did you determine if the tunnel SA supports more than one subnet?
answered Sep 24 by ltomlin New to the Community (1 point)
...