Home/Support/Support Forum/WR11 XT bridge mode
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

WR11 XT bridge mode

0 votes
Hello all,

I'm using the Digi TransPort WR11 XT with latest firmware. Main purpose is to place the device in bridge mode (aka IP Passthrough) and use a Cisco router behind it.

When I'm using the normal mode with NAT I can set a default route in my Cisco to the WR11 Xt and am able to use internet on the Cisco. However I want to bridge the Digi TransPort so it is transparant to the Cisco router.

In this mode I do receive the 4g mobile WAN IP address on my outside interface from the Digi TransPort but internet is not working. I'm using a default route on the cisco e.g.
ip route 0.0.0.0 0.0.0.0 10.9.8.1
In this example the WAN IP is 10.9.8.20 - I know you have to set .1 as default gateway.
I can ping the default gateway as well.

Any suggestions?
Thanks in advance.

Will
asked Jun 18 in Digi TransPort Cellular by digi076 New to the Community (0 points)

Please log in or register to answer this question.

...