Home/Support/Support Forum/Configure Xbee SC2 to faster communication
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Configure Xbee SC2 to faster communication

0 votes
Ver sitio web traducido
I have two Xbee SC2 modules.

I need to use an Xbee to make an ADC simply by feeding with an external 3.3 volt source. The Coordinator is connected to a computer and will receive the data from the "Router" or "End Device" The problem is that this source is a charging pump and I need to configure the devices to optimize the connection time between both devices. If I connect both devices via USB the data sending takes less than a second but if I use the 3.3 volt source it takes about 10 seconds and this may not be possible. I need to set them up to send as fast as possible.

The possible firmwares i can load on xbees are:

- 802.15.4.TH
- DigiMesh 2.4 TH
- ZIGBEE TH Reg.

Any ideas?

Thank you in advance
asked Jun 28 in USB Serial by ggutierrez New to the Community (0 points)

Please log in or register to answer this question.

...