Home/Support/Support Forum/Sending gps commands through xbee

Sending gps commands through xbee

0 votes
I am currently working with a setup like this:
gps adafruit receiver -> xbee 1 [100 ft] xbee 2 -> arduino

I have managed to figure out how to send the necessary gps data from the receiver to my arduino and print it. I am wondering if there is any way to send gps commands back into the gps receiver (through rx) using serial pass through. I would need to send a message to the receiver like "$PGCMD,33,0*6D" to change the settings on the gps itself... this should be possible but im not entirely sure how to do it. Any suggestions would be appreciated.
asked Jul 17, 2019 in XBee3 802.15.4 by daveb123 New to the Community (0 points)

Please log in or register to answer this question.